Drawers size

[J. Landman Gay]

On 2/12/04 5:09 PM, Thomas McGrath III wrote:

> I wasn't in the commode but, the way I went about it did not seem to 
> work. So I was hoping that some one with a bit more experience than me 
> had done it.

>>> To anyone,
>>>
>>> Also, can I set the size of a drawer to any size? right now it seems 
>>> it is the same size as my parent stack?????

I think what Klaus was saying was just that you should be able to set 
the stack size normally and then open it with the "drawer" command -- 
except that the stack can't be larger than its parent or else it can't 
slide out properly. I haven't tested that, but it sounds right. I 
suspect Rev will resize a large stack before "drawering" it if it is 
originally too big.

So, just set the rect of the card to a size smaller than the parent 
stack and then open it using the "drawer" command and see what happens.

-- 
Jacqueline Landman Gay         |     jacque at hyperactivesw.com
HyperActive Software           |     http://www.hyperactivesw.com